Activity Stream

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 05:23 PM

michel replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Started #720 today and getting to know the beast. Is the gear lever original? My other Series have "crooked" levers, but this one looks like it from...

653 replies | 177727 view(s)

Today, 03:45 PM

frmass replied to a thread Transmission/gear issue, 62 Series iia 109...w/200TDI Defender Engine in Land Rover Series I, II, IIA & III

Hi JP, thanks for the reply. Here’s what I’ve sorted so far since my last post... -Took off the overdrive unit, no obvious failures, all turned...

5 replies | 166 view(s)

Yesterday, 12:26 AM

RoverRod replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Thanks Michel and understood. Good luck with the new one! Rod

653 replies | 177727 view(s)

12-13-2019, 02:34 PM

jeellis2 replied to a thread 1981 Series III Short Wheel Base - Right Hand Drive in Series I, II, IIA, III

Hi Paul, Sorry about the delay, I guess I thought I'd get some sort of email notification if I had a reply on here, no such luck! Anyways, the...

3 replies | 282 view(s)

12-13-2019, 10:05 AM

laxdadnc started a thread Door handle interchangeable? in Land Rover Series I, II, IIA & III

Can the front right (passenger) door handle be installed on the rear door (1974 series 3)?

0 replies | 53 view(s)

12-12-2019, 10:55 PM

desullivan replied to a thread Series 2A 109 SW NADA rear brake drum advice in Land Rover Series I, II, IIA & III

Cylinders from host. Trying to post photos. I will take photo with measurements in few days. Currently out of town. No brake lines attached yet...

3 replies | 103 view(s)

12-12-2019, 10:52 PM

desullivan replied to a thread Series 2A 109 SW NADA rear brake drum advice in Land Rover Series I, II, IIA & III

3 replies | 103 view(s)

12-12-2019, 10:05 PM

clearcut replied to a thread Series 2A 109 SW NADA rear brake drum advice in Land Rover Series I, II, IIA & III

can you post a picture of the shoes? I may have a set in storage, that I could compare too. Use ruler in picture? have you check the...

3 replies | 103 view(s)

12-12-2019, 07:42 PM

desullivan started a thread Series 2A 109 SW NADA rear brake drum advice in Land Rover Series I, II, IIA & III

Series 2A 109 SW NADA rear brake drum left rear drum is about 1 or 2 mm to narrow for the pads. These pads are aftermarket and are same ones taken...

3 replies | 103 view(s)

12-12-2019, 04:56 PM

siiirhd88 replied to a thread 1966 Series IIa pentronix ditributor upgrade in General Discussion Area

There are two different triangular "Y" shaped aluminum spacers or mounts that fit between the distributor and the engine block. One is thinner than...

1 replies | 76 view(s)

12-12-2019, 02:44 PM

oldenglish replied to a thread 1981 Series III Short Wheel Base - Right Hand Drive in Series I, II, IIA, III

Anybody out there ? How do I get a hold of you ?

3 replies | 282 view(s)

12-11-2019, 10:59 PM

michel replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Hi Rod. Got your PM and replied. Thanks, Michel

653 replies | 177727 view(s)

12-10-2019, 03:47 PM

cedryck replied to a thread Alternator in generator shell in Land Rover Series I, II, IIA & III

Wow this is the first time I am seeing one of these , fantastic. I have an AC delco alternator in my 2A. But that is cool!!

1 replies | 99 view(s)

12-09-2019, 09:03 PM

jp- replied to a thread Replacing brake line in Land Rover Series I, II, IIA & III

PO modification.

2 replies | 130 view(s)

12-09-2019, 08:49 PM

jp- replied to a thread Transmission/gear issue, 62 Series iia 109...w/200TDI Defender Engine in Land Rover Series I, II, IIA & III

That spring loaded brass plug holds a detent in place for the 4-Lo/2-Hi shift rod. First thing you need to do is to see what is working and what...

5 replies | 166 view(s)

12-09-2019, 11:59 AM

brooks.copeland started a thread 1966 Series IIa pentronix ditributor upgrade in General Discussion Area

Restoring my 66 series IIa 2.24 engine and decided to upgrade the ignition with a Pentronix distributor p/n PRTXD176600. Seems like it's an 1/8" +/-...

1 replies | 76 view(s)

12-08-2019, 04:20 PM

RoverRod replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Hi Michel, did you receive the PM I responded to yours with? Not showing in my sent folder for some reason? Thanks, Rod

653 replies | 177727 view(s)

12-08-2019, 04:13 PM

RoverRod started a thread Fc101 in Land Rover Vehicles Wanted

Anything available? Thanks, Rod

0 replies | 79 view(s)

12-08-2019, 04:12 PM

RoverRod started a thread Wanted FC 101 in Forward Control 101

Hello, pretty quite here, but wanted to post and let folks know I'm looking for one of these. Anyone know of any here in the States, please let me...

0 replies | 81 view(s)

12-08-2019, 02:07 PM

RoverRod replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Jim, As always, thank you for the response and ongoing information. Best regards, Rod

653 replies | 177727 view(s)

12-08-2019, 12:48 PM

IIA replied to a thread Replacing brake line in Land Rover Series I, II, IIA & III

I removed the floor panel and that let me trace the brake pipe. So I answered my 1st question but now have another - yes, that is the brake pipe in...

2 replies | 130 view(s)

12-08-2019, 12:39 PM

patrickfoley1 replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

I have a spare Head in Storage. I'll check it for a part number. I have been unable to reach my old UK source, Alan Ramsbottom, to determine if he...

653 replies | 177727 view(s)

12-08-2019, 11:41 AM

frmass replied to a thread Transmission/gear issue, 62 Series iia 109...w/200TDI Defender Engine in Land Rover Series I, II, IIA & III

Another question- There is a spring loaded bolt on top of the transfer case. What is this for?

5 replies | 166 view(s)

12-08-2019, 11:39 AM

frmass replied to a thread Transmission/gear issue, 62 Series iia 109...w/200TDI Defender Engine in Land Rover Series I, II, IIA & III

Thanks for the reply. Correct, no gear in any gear including revers. But I can feel it, from the gearshift, going in to gear. Or at least it feels...

5 replies | 166 view(s)

12-07-2019, 07:41 PM

IIA started a thread Alternator in generator shell in Land Rover Series I, II, IIA & III

Has anyone tried one of those alternators that are designed to look like a Lucas generator? I've seen a couple online, for example: Here and ...

1 replies | 99 view(s)

12-07-2019, 05:38 PM

IIA started a thread Replacing brake line in Land Rover Series I, II, IIA & III

I'm replacing a leaky brake line in my 1970 Series IIA LHD. The offending line is the one that connects the rear right wheel to the front end. I've...

2 replies | 130 view(s)

12-07-2019, 10:16 AM

RoverRod replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Too bad to hear about 808 as that would be latest one on the registry list at the beginning of this thread. If you have an interest in trying to put...

653 replies | 177727 view(s)

12-07-2019, 01:23 AM

michel replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

I also have #808 which doesn't have much original parts left. The only original parts left are the bodywork (apart from the bulkhead) and the body is...

653 replies | 177727 view(s)

12-06-2019, 06:50 PM

RoverRod replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Hi Jim, I have sent you an email request for the photos; thanks very much for continuing to share your vast knowledge on these NADA's. So further...

653 replies | 177727 view(s)

Welcome to the Rovers North Land Rover Forums. Register A New Account.

Browse Rovers North's Parts Catalog:

About us

Links

Join us