1972 Series III 109" Wagon For Sale

[hrcheek]

This is my first post so I am asking for forgiveness ahead of time if I screw it up.

I have a 1972 Series III, titled in MS, 109" wagon that is for sale. I bought it a few years ago under the plans of stripping it down and doing a complete rebuild. The truck ran fine, but the transmission needed some work. I stripped it down to the frame and jerked the drive train out. I had the transmission worked on. I had the frame sprayed, added new shocks and springs. I also had purchased two new rear doors for it as well. Needless to say I cannot put it back together under the current economic conditions and would like to sell it. I have all of the parts and most of them are labeled. I put the engine and transmission back on the chassis. If someone purchases it I can crate all of the parts up. I can even deliver for a reasonable price as this will be the simplest and cheapest way to go. This unfinished project will cost time and money and I do not have those right now to put into this project. I have started on it and now it is time to hand it over to someone else to finish.

$3,500.00





I have more photos I will add if I can figure it out.

Thanks,

hrcheek48@yahoo.com

[hrcheek]

[hrcheek]

[Explorer0863]

Location?

[hrcheek]

Kosciusko, MS 39090

[Explorer0863]

Thanks. Way too far from me. Good luck!

[lookrent]

This is my first post so I am asking for forgiveness ahead of time if I screw it up.

I have a 1972 Series III, titled in MS, 109" wagon that is for sale. I bought it a few years ago under the plans of stripping it down and doing a complete rebuild. The truck ran fine, but the transmission needed some work. I stripped it down to the frame and jerked the drive train out. I had the transmission worked on. I had the frame sprayed, added new shocks and springs. I also had purchased two new rear doors for it as well. Needless to say I cannot put it back together under the current economic conditions and would like to sell it. I have all of the parts and most of them are labeled. I put the engine and transmission back on the chassis. If someone purchases it I can crate all of the parts up. I can even deliver for a reasonable price as this will be the simplest and cheapest way to go. This unfinished project will cost time and money and I do not have those right now to put into this project. I have started on it and now it is time to hand it over to someone else to finish.

$3,500.00





I have more photos I will add if I can figure it out.

Thanks,

hrcheek48@yahoo.com

what engine Is in it?

[hrcheek]

4 cyl diesel, 4 speed

[Mike Sabo]

Your rover in pieces is pretty much exactly what I have been looking for. Please reply to: Michael.Sabo@raymondjames.com
I can be reached toll free at 866-358-1991. / direct dial cell 412-849-349

[ecarbaat]

Still for sale? If so how much to box it up and deliver Jacksonville Florida, and is it complete? thank you please call 9122272214 and or email gimmeabreak@tds.net