Results 1 to 2 of 2

Thread: 2008 LR3 HSE ride height calibration issue

  1. #1
    Join Date
    Jan 2007
    Location
    Holly Ridge, NC
    Posts
    621

    Default 2008 LR3 HSE ride height calibration issue

    So we noticed that the ride height was off on the lr3 and we took it into the dealer to get it calibrated. Apparently the first time they did it, the calibration didn't stick, they did it again and the calibration failed within 2 hours.

    The techs said nothing was showing up as a fault, but they were going to reevaluate it again tomorrow. They ate stumped.

    Anyone had similar issues?

    Would/should bad sensors throw a code?

    Thanks
    First but gone: 91 3 door Disco "White Rhino"
    77 Series III 88 ex MoD "Shongololo"
    Gone and I miss her: 97 D1 5 speed
    04 DII
    08 D3 (LR3)

  2. #2
    Join Date
    Jan 2007
    Location
    Holly Ridge, NC
    Posts
    621

    Default

    Issue resolved, the service manager was a bit over zealous with his "eyeball" calibration and thought it fell out of tolerance. Service tech checked it and its good.
    First but gone: 91 3 door Disco "White Rhino"
    77 Series III 88 ex MoD "Shongololo"
    Gone and I miss her: 97 D1 5 speed
    04 DII
    08 D3 (LR3)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us