Results 1 to 3 of 3

Thread: Help! New 300 Tdi P Gasket leaking

  1. #1
    Join Date
    Feb 2007
    Location
    From Vermont, right now I am still traveling from west to east and back every year
    Posts
    37

    Default Help! New 300 Tdi P Gasket leaking

    Hi,


    I would like ask for some suggestion and experience. I just recently replaced the P Gasket on my 300 Tdi. It was an ordeal getting the water pump casing off the block since a bolt snapped and the rest was frozen in the old casing. I had to cut the bolt which them ruined the P gasket mating surface. I then ordered a used casing and put everything back together with a new metal gasket without any grease or sealant. I noticed it was seeping with the engine off. I tried tightening the three bolts but unfortunately it did not seem to work and it still seeps.


    I have been reading that sometimes old water pump casings will warp causing new gaskets to leak repeatedly when replaced. When I replaced it I cleaned up both services very well and did notice a small amount of corrosion on the aluminum but it did not seem enough to cause a problem. Possibly I was wrong? or do folks think it might be warpage? Has anyone had this same issue and solved it by getting a new casing?


    Thank you, I appreciate the help!


    Daniel Dubie

  2. #2
    Join Date
    Oct 2011
    Location
    Mountains of Western Pennsy.
    Posts
    509

    Default

    Hard to see this at long range.. But, I would first try to lightly coat the gasket with Gray RTV automotive sealer and also put thread sealer on all bolts. The Gray sealer might take up the imperfections in the casting, and the thread sealer would help prevent future problems with the bolts galvanic welding due to dissimilar metals and thus galling in place and later breaking off. A way to check if there is warpage in the casting is to set it on a glass plate, such as window glass, and try to rock it back and forth. Since this type of glass is dead flat it will show imperfections in the surface. If it does appear to be warped you can use the same glass covered with light sand paper and move the casting over it (lightly spraying with WD-40 or similar) until it is evenly shined up on both sides. Then recheck for flatness. If all else fails, a new one would be the best way out.

    '99 Disco II
    '95 R.R.C. Lwb (Gone...)
    '76 Series III Hybrid 109
    '70 Rover 3500S

  3. #3
    Join Date
    Nov 2007
    Location
    Saratoga NY
    Posts
    46

    Default

    For some reason I *thought* that the Rover workshop manual called for coating both sides of the P-gasket with some hylomar universal blue before install. I did this years ago when I had to do my prior 300, never leaked after install.
    Jason Lavender
    '71 Series IIA
    '88 127 #F96 DKN
    '94 NAS 90 #324
    '06 LR3 HSE
    www.SeriesDefender.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us