Results 1 to 2 of 2

Thread: Hand throttle control

  1. 07-26-2007, 09:36 AM #1
    PH4's Avatar
    PH4
    PH4 is offline 3rd Gear
    Join Date
    Jan 2007
    Posts
    375

    Default Hand throttle control

    Anyone ever install or remove a hand throttle control from a series? I have everything off except for the piece that attaches to the throttle rod (rod running along bulkhead). It appears that after all bolts removed it should just pull off but no such luck. Do I have to take the entire rod off to remove, hope not. Any tricks or prior experience? Advice appreciated.
    Reply With Quote Reply With Quote
  2. 07-26-2007, 12:46 PM #2
    jp-'s Avatar
    jp-
    jp- is offline 5th Gear
    Join Date
    Oct 2006
    Location
    North MS
    Posts
    980

    Default

    You don't have to take the entire rod off, but one end must come loose so that you can slide it out of the bulkhead. The hand throttle assembly itself has several hidden bolts. Make sure that you have them all off. There are one or two that bolt up through the lower gauge plate and several at the back, if I remember right.
    61 II 109" Pickup (Restomod, 350 small block, TR4050)
    66 IIA 88" Station Wagon (sold)
    66 IIA 109" Pickup (Restomod, 5MGE, R380)
    67 IIA 109" NADA Wagon (sold)
    88, 2.5TD 110 RHD non-hicap pickup

    -I used to know everything there was to know about Land Rovers; then I joined the RN Bulletin Board.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Links
Join us