Results 1 to 3 of 3

Thread: Series III transmission brake question

  1. #1

    Default Series III transmission brake question

    1974 Series III........Got all parts from host to replace everything in transmission brake. Was able to get everything out with driveshaft in and drum slid back over shaft. Parts flying everywhere but i was sure they would go back in pretty easy. Spent two hours trying to get shoes over shaft and springs on and other parts in order. Never got any of it done as in "zero" so just put parts on table and stopped work filthy, cut and mad. Am i going to have to pull shaft and flange on transmission to get this mess of stuff together. Surely someone has had this problem except me.
    Thanks

  2. #2
    Join Date
    Oct 2011
    Location
    Mountains of Western Pennsy.
    Posts
    528

    Default

    Do yourself a favor and drop the driveshaft. You'll save yourself a lot of trouble and have a little elbow room to work with.

    '99 Disco II
    '76 Series III Hybrid 109
    '95 R.R.C. Lwb (Gone...)
    '70 Rover 3500S (Gone...)

  3. #3

    Default

    I did just that this morning and also removed the drum flange. Everything went right into place and should have done this to start with. Guess i just needed a little frustration trying it with shaft in.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us