Results 1 to 5 of 5

Thread: Trick to attach inner wing to radiator?

  1. #1
    Join Date
    Feb 2016
    Location
    Central MA
    Posts
    29

    Default Trick to attach inner wing to radiator?

    Folks, any trick to placing the five +/- bolts per side through the inner wing into the side of the radiator housing? Too small to get my hand in there to hold the nut. There must be some trick to this.

  2. #2
    Join Date
    Feb 2016
    Location
    Central MA
    Posts
    29

    Default

    Never mind...there should be stud-plates instead of bolts with separate nuts. A prior owner must have swapped/lost the plates and just used multiple individual bolts. New stud plates ordered!

  3. #3
    Join Date
    Jul 2007
    Location
    Lebanon, PA
    Posts
    18

    Default

    Where did you order the stud plates from? I'm not finding them on RN, or not searching correctly.

    Thx,

    Don

  4. #4

    Default

    I ordered a set of bolt plates from YRM UK along with some other repair panels. Check them out.

    You could easily make new retainer plates with a piece of plate and bolts welded to the plate. Just a thought.

  5. #5

    Default

    just saw some of these available on eBay

    however they are located in Milan Italy - so not sure if that will make you think twice ...

    https://www.ebay.com/itm/NOS-Land-Ro...4AAOSwLfNeZ7kB

    https://www.ebay.com/itm/NOS-Land-Ro...kAAOSws6ReZ7p5

    there's two more listed as well ...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us