Results 1 to 3 of 3

Thread: Drive flange bolt leak

  1. #1

    Default Drive flange bolt leak

    Replaced my worn flanges about 2 weeks ago, and now one of them seems to be leaking from around a couple of the bolts.
    Would I be correct in assuming that I boogered the paper seal? The other side seems to be completely fine.
    Last edited by Erik M.; 07-04-2019 at 07:39 PM. Reason: I meant bolt, not stud (doh)

  2. #2

    Default

    Its more likely that the flange itself isn't flat - one side or the other. If someone used a hammer to knock it loose after removing the bolts, a small ding in the surface will result in leaks. I'd pull it, file the surfaces very carefully to look for a high spot (or actually face it on my 16" disc sander) and reinstall with some Permatex #2 non-hardening sealant after a good cleaning.

  3. #3
    Join Date
    Nov 2006
    Location
    Flagstaff, Arizona
    Posts
    1,085

    Default

    Being basically lazy, I would identify which bolts are the leak pathway, remove them, clean them, add a little RTV and put them back on (28 foot pounds torque)The oil is not under any pressure and a little RTV or form a gasket should seal the leak pathway. If it is leaking from the base of the drive flange I would pull the drive flange, clean it up and hit it with form a gasket. I don't use paper gaskets.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us