Thread pitch on series oil pressure sensor...

[KingSlug]

I am swapping in an 2.5 oil filter housing and want to hook-up the banjo bolt for the pressure gauge from a series. Unfortunately the housing is a 10mm bolt an the bolt is a 3/8", but I don't know the pitch. Its not a normal pitch count. Anyone know if its an NPT or something else? I going to helicoil the hole, to match the bolt but dont know the pitch needed.

Jared

[JAy]

I'm pretty sure it's british standard fine, the fine version of Whitworth. It was on my S3. Pretty much the only part on it with a british thread.

[PH4]

I may have an extra. Was going to use but put on spin on oil filter with adapter. You can email me at jhayes@ycrlaw.com.

[KingSlug]

Looks like the sender is 3/8"BSF and the sender hole is 10Mx1.5. The PO had a 3/8"BSF in a 10M hole, stripping out the housing. So now I need a 10M.1.5 banjo bolt, a 10Mx1.5 helicoil. Maybe I can drill and tap one of the extra plugs for the 3/8"BSF for the sender.

Heres what the housing looks like:
http://vivalaant.files.wordpress.com...ing1-small.jpg

Here some good info:
http://www.holden.co.uk/displayprodu...Gauge+Fittings

PH4, thanks for the offer but it looks looks like there are several places to get bolts, even 10Ms for a 3/8" banjo. http://www.jdaent.com/desktopdefault...814&CatID=1044

Jared