I had a great experience dealing with Peter. Bought several plates from him and he was very helpful in getting me the right ones. There are several options, including:

- the size of hole (for the standard size gauges) or he might be able to custom punch these or order with no holes and DIY for a custom gauge or switch

- one, two, or no holes

- hole at top or bottom if one

- right or left handed

- with the side panel that covers up the wiring, or without (i.e.- if you wanted to put several side-by-side, you probably don't want the side panels except on the ones that are at the outer ends of the grouping)

- with or without the notches for the vent lever brackets, etc.

I got a later wiper motor cover from Pangolin for a different project (lots o' switches). Great to deal with too.