Hi folks,

LR newbie here...I've just inherited stewardship of a '94 Disco 1 with a 5-speed and 171k on the clock. It has not been cared for terribly well, with a lot of deferred maintenance, but I do all my own wrench-turning so it'll get caught up in time. It's not a daily driver but rather an occasional-use (read--poor weather) vehicle.

The biggest issue of concern is some considerable rust in the rear wheel arches. Driver's side is the worst, with a significant hole visible in the horizontal surface under the door striker. The rot continues around the arch in both directions. The passenger side is not as bad but is on its way.

I'd like to look into repairing this rather than letting it get much worse. Is that feasible, and if so are there panels available anywhere for this section?

Thanks much!