Low Range
Searching for bulkhead details
I'm searching for prints of the 2a or 3 bulkhead that shows dimensions used for fabricating the individual parts.
Any format will work. I'm trying to avoid tearing mine apart until I have the panels made to replace them.
I could and might blueprint mine but if somebody has done it already it would save some time.
Bill Fishel
2nd Gear
Try the UK restorers, Pegasus and Ashtree? There are many models of series 2-2a bulkheads. gene
Low Range
At this point, I don't care if it is a 2a or 3 bulkhead. Carriage cost is a deal breaker for now.
Bill Fishel
2nd Gear
I didn't mean for a new one, I meant for blueprints. gene
Low Range
What portions of the bulkhead do you need to replace? I made up a few templates and patch panels earlier this year that I would be happy to take dimensions off of for you if they'll work. The patches I made were for the sides of the foot wells, on the exterior side (not the transmission cover).
Also, where abouts are you located?
~Neil
1974 Series III 88
1955 Chevy 3200 truck
Low Range
Neil
I'm in N.E. Ohio. I'm mostly interested in the upper bulkhead. Mine is rusting from the inside up around the vents and where the windscreen sits. Foot wells are not a problem to measure and make.
Bill Fishel
3rd Gear
where are you located?
1965 109 2door hardtop (restored years ago)
1971 88 (restored and as new)
1967 88 (the next project)
Low Range
Near Warren Oh.
2nd Gear
Someone was giving away a 2A bulkhead in the Guns&Rvrs site. It came with rust but could be used for parts.
Post a picture of the sections/areas you need patch panels as i'm also in the process of repairing my bulkhead and may have some left over from my donor bulkhead.
1972 NAS Series 88 SW
Low Range
Searched for the 2a bulkhead but no go.
Bill Fishel
Posting Permissions
Reply With Quote