The oil pressure sensor will look something like this.
http://www.ebay.com/itm/NOS-AC-OIL-P...-/160627667315
The oil pressure sensor will look something like this.
http://www.ebay.com/itm/NOS-AC-OIL-P...-/160627667315
1956 86" S1
1957 88" S1
1967 109" SIIA NADA
2007 LR3
for a 2.0 the oil sensor (for green idiot light) is at back bottom left of the engine at supply end of feed pipe for the rockers. For 2.25 at filter housing.
THING 1 - 1973 88 SIII - SOLD
THING 2 -1974 88 SIII Daily Driver - SOLD
THING 3 - 1969 88 SIIA Bugeye Project
THING 4 - 1971 109 SIIA ExMod - SOLD
THING 5 - 1958 109 PU
THING 6 - 1954 86" HT
Here is the old sensor. I need to check and see if it has electrical power. Pretty sure it's kaput.
1958 Series I
The Land Rover Series One Club is a good source for parts and information....all in the UK. Many parts seem interchangeable until you get to the Whitworth threaded part.
My rear frame member isn't totally shot, but has it's share of rust and rot. Rover's North has the kit - my main question is will it fit?
Well that was fun but enough rhyming. They have the rear frame member for the s2-s3 88" which looks exactly like my s1 88. I doubt they changed it, the dimensions are probably the same, any thoughts before I purchase it?
1958 Series I
They aren't the same. A Series 2 is a few inches wider than a Series 1. There may be other differences, but that's the most obvious.
'55 SI 86
Listen to Meat. Call Ike at Pangolin. Sign up on LRSOC.
'53 80" in my garage