Steering Relay Refit Orientation

[roverp480]

Hi all, I have searched but have been unable to find clear instruction on how to refit the steering relay. The shop manual states "ensure the cast projection on the upper side of the relay housing is fitted to the driver's side of the vehicle". Is that referring to RHD or LHD? Is it possible to fit the relay wrong where it would then have to be rotated 180 degrees? I have seen pictures of restored LHD vehicles with the casting on the relay pointing both left and right. Does it matter which way it's installed?
Thx,
Ben

The way I read it is the boss should point to the drivers side of the vehicle.ie if Left hand steering the boss should be pointing to the left . The illustration in the manual shows Right Hand steering fitting with the a note to say LH steering is symmetrically opposite . The orientation is to make sure one can access the filler, after installation, either a plug which is in the side of this boss or the fixing at the top adjacent to the boss . Often in practise no one checks the levels so the orientation if wrong, goes unnoticed.