Activity Stream

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 01:09 PM

mtbugeye replied to a thread BUGEYE Registry in Land Rover Series I, II, IIA & III

Forgot to include: D.O.B. February 28, 1969. Date of Despatch: March 6 1969 (They were gettin' them right out!

257 replies | 337375 view(s)

Yesterday, 12:43 PM

mtbugeye replied to a thread BUGEYE Registry in Land Rover Series I, II, IIA & III

Wanted to introduce "Popeye"(a Poppy-red Bugeye) to this R.N. "Bugeye Thread". This 88 is mostly original, solid and driven 1969 SIIA 88, Vin#...

257 replies | 337375 view(s)

12-08-2023, 03:34 PM

biffidum replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Certainly possible. If the pilot was wrong then for sure. Float level can affect everything too. If this problem happened after it was working...

16 replies | 2131 view(s)

12-08-2023, 02:34 PM

Poppy1969 replied to a thread Hardtop roof lining in Land Rover Series I, II, IIA & III

Hello. Here is what I did on my truck. I would recommend to have the top off the truck and do not attempt if weather is too cold. I used this...

4 replies | 1330 view(s)

12-08-2023, 01:41 PM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Thanks. All the jets are clean, but with the exception of the main, are the wrong number. Would this affect the idle?

16 replies | 2131 view(s)

12-08-2023, 01:20 PM

Poppy1969 replied to a thread '68 Series IIA Project Candidate in Series I, II, IIA, III

Hi Charles. Where is the truck located? Cheers. Tom

1 replies | 203 view(s)

12-08-2023, 10:52 AM

biffidum replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

The pilot jet would be the one likely plugged. If you have a wire set you could simple "poke" it clean. I wouldn't mess with the economy jet at...

16 replies | 2131 view(s)

12-08-2023, 06:40 AM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Thanks. Will do that. Is the "economy" jet listed in the workshop manual the same as the idle jet? I can't remove the economy jet as someone...

16 replies | 2131 view(s)

12-07-2023, 11:29 AM

cmcgahagin started a thread '68 Series IIA Project Candidate in Series I, II, IIA, III

I have a '69 Series IIA (88 & Gas) that I bought in '86 as a project for retirement, which never happened. Long story, but reality tells me I need to...

1 replies | 203 view(s)

12-07-2023, 11:28 AM

jimrr replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

yes

16 replies | 2131 view(s)

12-06-2023, 08:55 AM

roverp480 replied to a thread late series IIA heater valve in Land Rover Series I, II, IIA & III

I have just had a look at a copy of the operators manual for US vehicles with the fresh air heater and pushing the control in increases the heat...

5 replies | 3703 view(s)

12-06-2023, 08:39 AM

roverp480 replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Yes, timing based on Number One Cylinder

16 replies | 2131 view(s)

12-05-2023, 01:21 PM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Will check the carb. Thanks. I think the timing pointer is on the flywheel, not the crank pulley. Would I put the timing light on the front plug...

16 replies | 2131 view(s)

12-04-2023, 10:12 PM

tluchette69 replied to a thread late series IIA heater valve in Land Rover Series I, II, IIA & III

Found this while looking for info on the control knob to cable. The cable has slipped out and I don't have the allen key for what must be the...

5 replies | 3703 view(s)

12-04-2023, 09:53 PM

biffidum replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

In all carbs not able to achieve low idle often means your smallest jet is plugged or restricted. You are likely running (barely) on a secondary...

16 replies | 2131 view(s)

12-03-2023, 02:48 PM

jimrr replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

timing light goes to first plug closest to radiator, hook to battery as normal. timing pointer is on crank end by radiator and close to block,...

16 replies | 2131 view(s)

12-03-2023, 01:15 PM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

Hi. Yes, I am remiss with no engine bay pictures (nothing to hide there though). As far as the TBI goes, there are some very good threads on Guns...

6 replies | 2820 view(s)

12-03-2023, 06:40 AM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Hello. I adjusted the mixture screw and the idle. Not much apparent change using the mixture screw, but seems to idle better at a stop after...

16 replies | 2131 view(s)

12-01-2023, 01:06 PM

Aspenwood110 replied to a thread Super SIIa SWB in Series I, II, IIA, III

Some pictures of the engine bay would be helpful. I am considering a Holley Sniper for my 88 and I am curious how you did yours. Note that any one is...

6 replies | 2820 view(s)

11-28-2023, 10:29 AM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

It might be worth adding that Growler is well-suited for cold weather - it has a bunch of unique (custom?) features: - A snap-on clear plastic...

6 replies | 2820 view(s)

11-28-2023, 09:38 AM

redfoxrovers replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Previously owned 34300576A. Sold to a guy in New Baltimore, Michigan,1990 Presently own '69 88 Bugeyes, 1 running and registered in CT, 1 in parts

692 replies | 764844 view(s)