Activity Stream

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 08:55 AM

roverp480 replied to a thread late series IIA heater valve in Land Rover Series I, II, IIA & III

I have just had a look at a copy of the operators manual for US vehicles with the fresh air heater and pushing the control in increases the heat...

5 replies | 3625 view(s)

Today, 08:39 AM

roverp480 replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Yes, timing based on Number One Cylinder

11 replies | 1628 view(s)

Yesterday, 01:21 PM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Will check the carb. Thanks. I think the timing pointer is on the flywheel, not the crank pulley. Would I put the timing light on the front plug...

11 replies | 1628 view(s)

12-04-2023, 10:12 PM

tluchette69 replied to a thread late series IIA heater valve in Land Rover Series I, II, IIA & III

Found this while looking for info on the control knob to cable. The cable has slipped out and I don't have the allen key for what must be the...

5 replies | 3625 view(s)

12-04-2023, 09:53 PM

biffidum replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

In all carbs not able to achieve low idle often means your smallest jet is plugged or restricted. You are likely running (barely) on a secondary...

11 replies | 1628 view(s)

12-03-2023, 02:48 PM

jimrr replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

timing light goes to first plug closest to radiator, hook to battery as normal. timing pointer is on crank end by radiator and close to block,...

11 replies | 1628 view(s)

12-03-2023, 01:15 PM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

Hi. Yes, I am remiss with no engine bay pictures (nothing to hide there though). As far as the TBI goes, there are some very good threads on Guns...

6 replies | 2704 view(s)

12-03-2023, 06:40 AM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Hello. I adjusted the mixture screw and the idle. Not much apparent change using the mixture screw, but seems to idle better at a stop after...

11 replies | 1628 view(s)

12-01-2023, 01:06 PM

Aspenwood110 replied to a thread Super SIIa SWB in Series I, II, IIA, III

Some pictures of the engine bay would be helpful. I am considering a Holley Sniper for my 88 and I am curious how you did yours. Note that any one is...

6 replies | 2704 view(s)

11-28-2023, 10:29 AM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

It might be worth adding that Growler is well-suited for cold weather - it has a bunch of unique (custom?) features: - A snap-on clear plastic...

6 replies | 2704 view(s)

11-28-2023, 09:38 AM

redfoxrovers replied to a thread 109 NADA Registry in Land Rover Series I, II, IIA & III

Previously owned 34300576A. Sold to a guy in New Baltimore, Michigan,1990 Presently own '69 88 Bugeyes, 1 running and registered in CT, 1 in parts

692 replies | 761980 view(s)

11-27-2023, 01:32 PM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Thanks again.

11 replies | 1628 view(s)

11-27-2023, 11:40 AM

jimrr replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

unless you have a manifold to head leak which would be harder to find just look at the hoses coming off the intake manifold and carb. removing the...

11 replies | 1628 view(s)

11-27-2023, 06:18 AM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

How do I check for a vacuum leak? Thanks

11 replies | 1628 view(s)

11-26-2023, 04:42 PM

Robert replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Thanks, I'll check it out.

11 replies | 1628 view(s)

11-26-2023, 04:17 PM

roverp480 replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

Check the idle mixture strength is correct, may be slightly weak. If you snap the throttle open from idle then back to idle does it stall then? WS...

11 replies | 1628 view(s)

11-26-2023, 03:13 PM

jimrr replied to a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

vacuum leak !! .......... check that spring on the flapper valve atop the carb intake too.

11 replies | 1628 view(s)

11-26-2023, 10:54 AM

Robert started a thread Engine dies at stop light. Need advice on adjustments in Land Rover Series I, II, IIA & III

1963 88 NADA with Solex carburetter. Idle, acceleration and running are fine. When pulling up to stoplight and clutch in, engine wants to die. ...

11 replies | 1628 view(s)

11-25-2023, 09:07 PM

tluchette69 replied to a thread Seat straps in Land Rover Series I, II, IIA & III

Good point, I was starting to think the same. I'll try that first.

7 replies | 3297 view(s)

11-25-2023, 02:08 PM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

Hi. I just realized this is primarily an American site. I am in Canada and would not expect to get $US27,500 for it. With exchange, $20,600 is my...

6 replies | 2704 view(s)

11-24-2023, 09:36 PM

jp- replied to a thread Seat straps in Land Rover Series I, II, IIA & III

These are screwed directly into the seat backs on the originals. I don't think you need the spire nut. They aren't holding much force. I'd try...

7 replies | 3297 view(s)

11-23-2023, 11:25 AM

tluchette69 replied to a thread Seat straps in Land Rover Series I, II, IIA & III

Yes, I bought the parts from the first diagram. Looks like I have to cut a square hole in the Masonite panel on the seat back to accept that spire...

7 replies | 3297 view(s)

11-23-2023, 09:47 AM

alwaysarover replied to a thread Super SIIa SWB in Series I, II, IIA, III

Bad time of year?

6 replies | 2704 view(s)

11-21-2023, 08:57 PM

jp- replied to a thread Seat straps in Land Rover Series I, II, IIA & III

There most definitely are seat straps. The 109 SW straps fasten around the bar to a metal post. The 109 2 door and 88's fasten to the rear bulkhead...

7 replies | 3297 view(s)

11-21-2023, 11:35 AM

MJL replied to a thread Hardtop roof lining in Land Rover Series I, II, IIA & III

Thanks for the feedback guys. I know what you mean about leaving things to an experienced upholstery expert. Years ago I attempted to replace the...

3 replies | 1250 view(s)

11-21-2023, 04:05 AM

roverp480 replied to a thread Seat straps in Land Rover Series I, II, IIA & III

Is this of any assistance Or with metal backed seats

7 replies | 3297 view(s)

11-20-2023, 02:26 PM

charles1943 replied to a thread Hardtop roof lining in Land Rover Series I, II, IIA & III

Regrettably unless u r a seasoned upholstery expert the job usually results in a headliner that sags and wrinkles and doesn't match the original....

3 replies | 1250 view(s)

11-20-2023, 12:15 PM

tluchette69 replied to a thread Seat straps in Land Rover Series I, II, IIA & III

It appears this was an option. I’ve already purchased the leather straps and installed the studs on the bulkhead behind the seats. I’ve seen pics of...

7 replies | 3297 view(s)

11-19-2023, 06:19 PM

roverp480 replied to a thread Hardtop roof lining in Land Rover Series I, II, IIA & III

I recovered all the parts on a hardtop roof lining and all the other items of trim with the same outer using new material from LR . Unfortunately it...

3 replies | 1250 view(s)

11-17-2023, 06:21 PM

MJL started a thread Hardtop roof lining in Land Rover Series I, II, IIA & III

Has anyone replaced the roof lining in their Series III recently. Any pointers on where the appropriate parts can be sourced? Tips on installation...

3 replies | 1250 view(s)

Welcome to the Rovers North Land Rover Forums. Register A New Account.

Browse Rovers North's Parts Catalog:

About us

Links

Join us