I just got my brackets and not sure which way is up. I was wondering if someone can take a pictures of one. Thanks
Rear Liftgate Brackets
Collapse
X
-
Rear Liftgate Brackets
1968 Series IIa 88 w/ hardtop - SOLD
1970 Series IIa 88 (parts car)
M416 Trailer
2008 Toyota FJ
2009 Volvo C30
1983 D110
http://68landy.blogspot.com/2010/01/blog-post.htmlTags: None -
There are some photos in the following thread: http://www.roversnorth.com/forums/showthread.php?t=9267'62 109 - coil sprung
'64 88 - coil sprung -
Thanks. I have 2 left hand side brackets and they will not even fit on the left hand side. Based upon the pictures, I am going to cut off about 1/4 of an inch and they should be fine.1968 Series IIa 88 w/ hardtop - SOLD
1970 Series IIa 88 (parts car)
M416 Trailer
2008 Toyota FJ
2009 Volvo C30
1983 D110
http://68landy.blogspot.com/2010/01/blog-post.htmlComment
-
I think I misunderstood which brackets you were referring to. You are talking about the ones that get riveted to the hardtop? These can be a tight fit and may need to be tapped into place with a hammer. It may be best to try and source a RH version rather than trying to hack the LH one to fit. Below is a little better photo showing an original set-up.'62 109 - coil sprung
'64 88 - coil sprungComment
-
Yes, that is the picture I was looking for. I cannot find a right hand side bracket. I bought the last 2 left hand side from RN this week. I was told the Right hand side are no longer available.1968 Series IIa 88 w/ hardtop - SOLD
1970 Series IIa 88 (parts car)
M416 Trailer
2008 Toyota FJ
2009 Volvo C30
1983 D110
http://68landy.blogspot.com/2010/01/blog-post.htmlComment
Comment