glbft1
12-29-2010, 12:26 PM
Hello All,
Getting ready to install a new slave cylinder, the old one is leaking, the line seems good, looks straight forward just wondering about adjusting the rod, should I measure and then install and adjust to the old length or is there something I missing or do I have to adjust at all??
Any advice on anything I am missing or shortcuts :thumb-up:
Getting ready to install a new slave cylinder, the old one is leaking, the line seems good, looks straight forward just wondering about adjusting the rod, should I measure and then install and adjust to the old length or is there something I missing or do I have to adjust at all??
Any advice on anything I am missing or shortcuts :thumb-up: