View Full Version : WANTED: Pics of Inertia Seatbelts
NC Rover
01-28-2011, 12:07 PM
Looking for some pictures of anyone with inertia shoulder belts in their Series rovers. Mainly looking for pictures of the attachment points where the belts are mounted.
thanks!
NIck
jac04
01-28-2011, 12:27 PM
Hard top or soft top?
ducttape
01-29-2011, 06:24 AM
Soft top
:D
I am adding a soft top to my truck (from it's current hard) and need to figure out belting too.
I'd like to be able to switch back and forth, although I don't know how much I will end up doing that.
Cutter
01-29-2011, 06:36 AM
I'll take some pics, I just properly installed the set in mine, though my 109 has a hard top so no help on the shoulder bracket. At some point I'd like to fabricate or buy a bar that will mount them so I can run without the top.
rejeep
01-29-2011, 08:10 AM
i instaled defender ones in my 109 SW..
I can prob grab pics tomorrow when I get up to the shop..
they were a lot simpler to install than I thought they would be.
Les Parker
01-29-2011, 09:32 AM
Here's a copy of the Defender 90/110 seat belts that I fitted to the Airportable some time ago :-
4628
Hope this helps, please note you have to remove this when fitting truck cab or hard top roofs !
Looking for some pictures of anyone with inertia shoulder belts in their Series rovers. Mainly looking for pictures of the attachment points where the belts are mounted.
thanks!
NIck
Here is my setup on my series 3:
http://www.tukojack.com/images/seatbelt_b1.jpg
http://www.tukojack.com/images/seatbelt_b2.jpg
Todd.
Cutter
01-29-2011, 06:26 PM
here's the reel mount on my 109 p-up. the bracket shown is mounted to a lower bracket under the seat box that attaches to the frame outrigger. For a long while mine was just attached to sheet metal which didn't provide much protection. Sorry its not the best photo, tight quarters back there.
http://kaijustudios.com/cutter/inertia_mount.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.