73series88
02-06-2011, 08:40 AM
good morning folks,
well i finally got the pieces to change my thermostat over to the domed type with new housings and everything, almost. i guess the top of the housing is NLA so i crudely machined out the old one to fit.
heres my question.
where in the assembely does the the o ring fall in?
only place i can figure is between the the lower housing and the thermostat. not sure.
i just want this beast to go smoothly up to winter romp.
thanks alot.
aaron
well i finally got the pieces to change my thermostat over to the domed type with new housings and everything, almost. i guess the top of the housing is NLA so i crudely machined out the old one to fit.
heres my question.
where in the assembely does the the o ring fall in?
only place i can figure is between the the lower housing and the thermostat. not sure.
i just want this beast to go smoothly up to winter romp.
thanks alot.
aaron