View Full Version : converting to s111 power brakes
chefplw
02-23-2011, 05:59 PM
I was wondering if anybody could give me some info. I think that I remember reading somewhere that I need to trim the inner fender to fit s111 sevro and master cylinder. It going into s11a 109 rhd. hoping for a pattern or measurements so I dont hack it to badly.
siiirhd88
02-23-2011, 06:53 PM
Here are photos of an early LHD SIIA wing and a later SIIA wing that shows the cutout for the brake master cylinder. The cutout is similar for a RHD truck.
Bob
LaneRover
02-23-2011, 07:13 PM
Before you take the wing off the truck to cut it, mark it with a marker/tape whatever to show how far the hood goes and thus how much the hood covers. Don't go past that (or stay inside of it by an inch or so) and you should do pretty well.
TeriAnn
02-23-2011, 09:29 PM
I wrote a little bit about it once.
maybe you can find something useful here:
http://www.expeditionlandrover.info/dual_brake_conv.htm
Good luck with your project.
leafsprung
02-23-2011, 10:41 PM
http://www.pangolin4x4.com/pangolin4x4/projects/pbr/powerbrakemod.jpghttp://www.pangolin4x4.com/pangolin4x4/projects/pbr/cutoutlip.jpghttp://www.pangolin4x4.com/pangolin4x4/projects/pbr/cutout.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.