Clutch will not disengage

[crankin]

I rebuilt my clutch mc and slave today. I had to remove the nuts that hold the mc in place and replaced when the job was done....trying to get the placement about right. Went to start it up in neutral and with foot on the clutch moved into reverse and it started going.

What's wrong here?

[KevinNY]

Did you refill and bleed the system? Sounds like you have zero hydraulic pressure, bleeding should do it.

[crankin]

Yes. I bled the system and had zero bubbles.

My thoughts are that i need to break down the mc and slave and make sure that i am not a idiot and put it back together correct. But there doesn't seem like a whole lot to mess up...