View Full Version : Rear lamp inner panel ?
LH Drive
04-10-2007, 10:24 PM
I've searched and can't find a diagram of the panel cover for the rear signal light wires inside the bed of a NAS Series 3. I need the panels that also cover the reverse lamp wires, they should be square as there is an outline where the original covers were. Does anyone have a picture so I can make some covers?
Why make them? Ask our hosts (ask for Les) and they will send out a used set for you.
These are quite common... No need to make them.
Bostonian1976
04-11-2007, 07:11 AM
these? :)
http://cgi.ebay.com/ebaymotors/Series-Land-Rover-Rear-Lamp-Panels_W0QQcmdZViewItemQQcategoryZ6763QQihZ011QQit emZ320101659244QQrdZ1QQsspagenameZWDVW
Those are what I was thinking of, but 1965 did not have the back-up lights, so the cover may be different for the later trucks with back-up lights in the rear panel inboard of the stop lights.
The Defender panels might work too- Mine are cut to clear the roll cage, but I think they are very similar to my late II-a covers. The Defender re-located the back-up light, so it is not inboard of the stop lights any longer. Mine is at the bottom of the tub.
PS: my truck is ROW spec, NOT NA spec. The lights are different...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.