View Full Version : choke sending unit
rejeep
10-04-2011, 05:50 PM
I noticed that some heads have a electronic choke sending unit..
is there a blanking plate as well?
jac04
10-04-2011, 05:59 PM
Yes, there is.
You can make one quite easily. Put masking tape over the hole, including the screw holes. Rub the tape with a screwdriver handle (or similar) until you can see the outlines of the holes and the boss in the head casting. Remove tape, transfer to a piece of steel, and use it as a template for cutting out a blanking plate.
rejeep
10-04-2011, 06:02 PM
avail from hosts? or ?
luckyjoe
10-05-2011, 09:59 AM
I'm pretty sure RN can supply masking tape with the green/white label, but that's not really necessary...
rejeep
10-05-2011, 12:35 PM
funny
jac04
10-05-2011, 12:39 PM
Atlantic British supplied me one for use with my Turner engine that I purchased from them. You could try them or our hosts.
rejeep
10-05-2011, 01:40 PM
they dont have any...
I would be better off with the blanking plug anyway..
Les Parker
10-05-2011, 02:25 PM
RN can supply a good used "Otter Thermostat" that will fill the hole.
N/C on your next order.....
:thumb-up:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.