View Full Version : Pic needed-Series III pedals...
knac1234
10-11-2011, 09:48 AM
Hello all,
So here is another question....
Can anyone post a pic of where the pedals enter the footwell of a Series III?
I believe the return springs (1 on clutch/2 on brake) connect to a bracket(s) of sorts I believe in the footwell. I forgot to snap a photo of those and can't remember which brackets attach where so the springs are just dangling around right now.
Regards,
Julian
o2batsea
10-11-2011, 10:45 AM
Its a piece of metal with a fold down the middle that is attached across the top of where the pedal towers bolt thru. It has a couple holes in it for the springs.
knac1234
10-11-2011, 12:59 PM
Thanks o2,
I still would like a pic if anyone can help. I just have a lot of small brackets back from powdercoating, and need some help in identifying these (I assume there are more than 1 for both pedals.....and not sure if both look the same).
Regards,
Julian
SafeAirOne
10-11-2011, 01:17 PM
http://farm7.static.flickr.com/6113/6234718371_696da61bb1_z.jpg
Jim-ME
10-11-2011, 01:21 PM
My pedal only has one spring but it works unlike other parts of my Rover.
Jim
LaneRover
10-11-2011, 01:25 PM
http://farm7.static.flickr.com/6113/6234718371_696da61bb1_z.jpg
Right hand drive I see!
knac1234
10-11-2011, 01:26 PM
Mark,
Thanks! The clutch one is now easy.....oops where do those 2 springs go in the brake pedal?? Hope I don't have to remove it!
Julian
siii8873
10-11-2011, 03:31 PM
julian,
look up inside the brake tower, you will see two tabs with holes in them. That is where the srings connect at top
Bob
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.