Pic needed-Series III pedals...

[knac1234]

Hello all,

So here is another question....

Can anyone post a pic of where the pedals enter the footwell of a Series III?

I believe the return springs (1 on clutch/2 on brake) connect to a bracket(s) of sorts I believe in the footwell. I forgot to snap a photo of those and can't remember which brackets attach where so the springs are just dangling around right now.

Regards,
Julian

[o2batsea]

Its a piece of metal with a fold down the middle that is attached across the top of where the pedal towers bolt thru. It has a couple holes in it for the springs.

[knac1234]

Thanks o2,

I still would like a pic if anyone can help. I just have a lot of small brackets back from powdercoating, and need some help in identifying these (I assume there are more than 1 for both pedals.....and not sure if both look the same).

Regards,
Julian

[SafeAirOne]

[Jim-ME]

My pedal only has one spring but it works unlike other parts of my Rover.
Jim

[LaneRover]

Right hand drive I see!

[knac1234]

Mark,

Thanks! The clutch one is now easy.....oops where do those 2 springs go in the brake pedal?? Hope I don't have to remove it!

Julian

[siii8873]

julian,
look up inside the brake tower, you will see two tabs with holes in them. That is where the srings connect at top
Bob