PDA

View Full Version : Koenig winch parts



Billy5
10-14-2011, 05:14 PM
I figured I would through this out there. Does anyone know where I can get u joints for the driveshaft that runs it? Or even the whole shaft. Is it possible to just bring one down to auto parts an just match it? Also, any ideas for gaskets, or do i just get gasket material and make them. I know am most likely sol, but I thought I would try.

slorocco
10-17-2011, 06:36 PM
I used to have the crankshaft driven version on my 109. If I remember right it used standard sized spicer u-joints. I also made a quick mount mod on the drive shaft so it could easily be installed and uninstalled so the winch gear box was not running all the time. I would just put the driveshaft in when I was going off road etc.