View Full Version : T-Case / Gearbox
siii8873
10-22-2011, 01:24 PM
Am I correct that a IIA T-Case will mount to a SIII gearbox as is.
Terrys
10-23-2011, 06:48 AM
Yes. You're correct.
"
"
"
"
"
"
"
"
"Print this page and occasionally show your wife. Keeps them from thinking they are the only one.
jumpmaster54
10-23-2011, 08:46 AM
Will a series III transmission bolt to a IIa 6 cylinder?
Sarge
SafeAirOne
10-23-2011, 09:55 AM
Will a series III transmission bolt to a IIa 6 cylinder?
Sarge
If it is a 6-cylinder SIII transmission, then yes. Otherwise, not without a swap to a 6 cylinder bellhousing--The fasteners between the bellhousing and the flywheel housing are shifted x-many degrees clockwise (or anti-clockwise) on a 6-cylinder setup so if you were to attach a transmission with a 4-cylinder bellhousing, the shift lever would stick out at 11:00 or 1:00 as opposed to the normal 12:00.
TeriAnn
10-23-2011, 10:05 AM
Will a series III transmission bolt to a IIa 6 cylinder?
The Series I and the six cylinder engines share the same bellhousing bolt pattern. The SII & III four cylinder engines use a different bellhousing bolt pattern.
You can bolt a SIII gearbox intended for a 6 cylinder engine to a SIIA with a six cylinder engine.
You can also swap bellhousings during a gearbox rebuild.
jumpmaster54
10-23-2011, 11:07 AM
So what do I need to puth my series III tranny behind my series IIa engine? is it a special bell housing. I have both the 4 and the 6 cylinder housing.
siii8873
10-25-2011, 04:55 PM
terrys, like your response on bottom :):), missed that first time.
slorocco
10-26-2011, 06:51 AM
So what do I need to puth my series III tranny behind my series IIa engine? is it a special bell housing. I have both the 4 and the 6 cylinder housing.
Put the 6cy bell housing on the sIII tranny.
jumpmaster54
10-26-2011, 08:22 AM
Are there advantages to a series II tranny over the IIa such as the syncromesh
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.