jpetropoulos
07-10-2012, 08:32 PM
Well Magoo.....now you've done it.
We removed the body, bulkhead and carbeurator / accelerator linkage and now I cannot figure out how it is configured for reattachment. Does anyone have a good photo or source for a schematic of this setup? It is a 72 Series 3 Left Hand drive 4 cylinder with a Weber.
I need to know where to drill for the accelerator body to exit the foot well and where to mount the various bits that attach to the bulkhead and vertical frame member. I will also need to figure out which linkages attache to which bits. I have the workshop manual but it shows a right hand drive and many of the mounting pieces do not appear to be the same. In addition it does not show the bits mounted to the bulkhead / frame.
And I bought a camera so this won't happen again !
In humility,
Jack
We removed the body, bulkhead and carbeurator / accelerator linkage and now I cannot figure out how it is configured for reattachment. Does anyone have a good photo or source for a schematic of this setup? It is a 72 Series 3 Left Hand drive 4 cylinder with a Weber.
I need to know where to drill for the accelerator body to exit the foot well and where to mount the various bits that attach to the bulkhead and vertical frame member. I will also need to figure out which linkages attache to which bits. I have the workshop manual but it shows a right hand drive and many of the mounting pieces do not appear to be the same. In addition it does not show the bits mounted to the bulkhead / frame.
And I bought a camera so this won't happen again !
In humility,
Jack