I've replaced the lower bearing and race and the Railco bush and the top pin. I've got it right at 14 lbs. The green bible calls for 12-14 lbs when pulling from the steering arm. As all these parts are new, should I expect this resistance to go down over time and should I go for something a little higher? This would be a bit of a pain to check again once the vehicle was all assembled as you'd have to take off the track bar and drag link.
Railco bush adjustment question
Collapse
X
-
Limits are limits if the factory wanted more with new parts it might be "12-14lbs but 14-16lbs with new parts", the factory limits were taken into account during the design of the product, I wouldn't second guess the engineer that designed it.1971 series 2a 88, series 3 trans, Fairey OD, owned since 1978.
Comment