tmckeon88
10-19-2015, 07:08 PM
I recently had my cylinder head off and new valves put in due to a burned valve on the #1 cylinder. (Series IIA 88", 2.25 petrol engine.) I had a reputable mechanic do the valves. I've reattached the head, set the valve clearances and turned it over for a few seconds to get oil flowing. It does turn over fine. I'm wondering if anyone has advice about getting it started up and running in the new valves. I know I should check the head bolt torque and the valve clearances again in a while. Any other thoughts?
Tom
Tom