PDA

View Full Version : 2008 LR3 HSE ride height calibration issue



msggunny
04-28-2016, 06:15 AM
So we noticed that the ride height was off on the lr3 and we took it into the dealer to get it calibrated. Apparently the first time they did it, the calibration didn't stick, they did it again and the calibration failed within 2 hours.

The techs said nothing was showing up as a fault, but they were going to reevaluate it again tomorrow. They ate stumped.

Anyone had similar issues?

Would/should bad sensors throw a code?

Thanks

msggunny
04-29-2016, 07:24 AM
Issue resolved, the service manager was a bit over zealous with his "eyeball" calibration and thought it fell out of tolerance. Service tech checked it and its good.