Series 3 clutch stuck disengaged

[learyseamus]

Good morning, I've got a rover down. I've pulled the slave cylinder and flex line off the truck, and can still push it around with the truck in gear. High and low range. Before I parked it last, I was having trouble keeping a pedal, almost no spring back, and suspected an old flex line. The next day, the pedal was immobile, but could move freely through the gears. I opened the bleeder, and pushed the pedal and heard a pop like and obstruction was passed. Closed it, pulled the pedal up and rock hard again. Now, with slave out, i can move the fork by pulling the rod toward me, but springs back into the housing. Anyone ever this happen?
Cheers

[cedryck]

I might start with the hydrolics, make sure the master, and slave are funtioning properly, not likely a mechanical issue, but then again,

[SalemRover]

Take the slave cylinder out. Is the push rod there, OR did it pop out and get wedged against the aluminum housing. This is how my SIII clutch became stuck disengaged.