PDA

View Full Version : TRADE: My series III 109---- for an 88 or a series1



lowtiderides
07-07-2018, 06:34 PM
Looking to trade my 1979 RHD series III for an 88 or a series I.

I have had it for almost 3 years but looking to move into something smaller... One the past few years it has gotten daily use and can text video of it running.
Stuff done during the last 3 years
~New factory wheels painted in Limestone PPG
~5 235/85 R16 BFGs
~Engine gasket kit
~Valves adjusted
~NGK Spark Plugs
~Land Rover Factory wires
~New Electronic Dizzy
~Oil & Fuel Filters, Fluids, etc etc
~Master Clutch, Master Brake & Slave cylinder Lines
~Front Wheel Bearings, Brakes, Wheel cylinders
~Alternator, Fan Belt
~New Soft Top & New Soft Top Supports
~Hard Top Included with trade as well
~New Rear Seat

Frame is solid, bulkhead has typical rust but have the corner patches I can included or weld in if needed. I can also include a gallon PPG Factory Green paint. Like I said it will continue to get used daily until I find a smaller replacement. I just bought a new truck and no longer need two large vehicles.

Would prefer one with a hard top for the winter but its not a deal breaker if it doesn't. Would be great to have another RHD but also not a deal breaker.

Thanks for your time,
~Alexander

AlexanderEMcBride@yahoo.com
1281112810

Tom Santoli
07-09-2018, 09:59 PM
Alexander;

I have a 1978 RHD Series III hard top I’d consider trading; do you have more photos of your truck? I had a 109 years ago I regret selling.

I can send some pictures of my truck; it is on a galvanized chassis, has a Fairey overdrive and was recently converted from diesel to gasoline.

Other work/ details;

New one wire alternator.
New clutch
New door tops.
New radiator panel,
Repaired bulkhead pillars.
Previous owner installed OME shocks and parabolic springs.
New fuel pump.

Where are you located?

Thank, Tom