Adding a 12V socket and UBS ports to a Series 2

[roversii]

Hello all - I have a 1960 Series 2 SWB LHD and find it is about time to add a 12V socket and 1 or 2 USB ports. Any suggestions/best practices on where to put them, parts (e.g., 3A vs 10A socket) and wiring?

[nicsrover]

I put in a cigarette lighter type outlet and wired in to the inspection light wires (which is now disconnected as it was shorting out). I plug in a USB adapter when needed. Just bolted thru an existing hole in dash.

[AP22]

there is a handy little setup on eBay

https://www.ebay.com/itm/282278861670

[roversii]

Thanks for the eBay link AP22. I had also seen that and wondered if I should opt for a 10A socket instead of 3A?

[roversii]

I put in a cigarette lighter type outlet and wired in to the inspection light wires (which is now disconnected as it was shorting out). I plug in a USB adapter when needed. Just bolted thru an existing hole in dash.[ATTACH=CONFIG]13780[/ATTACH]

Thanks for the description and the photo @nicsrover.