My Cruise control was working until the other day anybody have an answer for me thanks for your help. Its on a 1995 disco 1. Thanks again
Cruise control
Collapse
X
-
I have the same condition on my Disco 1 (1999). Where exactly is the vacuum line in the engine bay and where does it go to/from?Comment
-
Follow the vacuum line that attaches to the rubber bladder in the engine compartment to ALL the connections and make sure there are no vacuum leaks. This is a starting point.
Recently, I was helping a Discovery I owner try to locate the best place to fit a Hella light wiring through the bulkhead and low and behold on our company Land Rover the "Y" cruise control line junction (near the bulkhead and brake booster) appeared to be normal until I touched it... .
The vacuum line was cracked on the underside.
Here is the thread >> http://www.roversnorth.com/forums/showthread.php?t=1459
Cruise control vacuum line goes down tot he "Y" in the area near the red arrow.
Last edited by TSR53; 09-06-2007, 01:12 PM.Comment
-
I finally tired of this re-occuring, and replaced ALL the vacuum hose - from the brake switch though the bulkhead, to the T-piece and vacuum pump under the left headlight.
No more problems... and working CC!
Regards,Tom P.
1965 exMoD 109
1995 RRC LWB w/EASComment
-
Thank you so very much for the advice (right on target). Although I feel unbelievably stupid that my cruise control wasn't working because of a disconnected vacuum tube I think that I can get over it quickly given that a mechanic didn't have the opportunity to empty my pockets. The issue was that it was disconnected where the line runs to the other side of the brake booster to where it connects to the throttle wires.Comment
Comment