PDA

View Full Version : How much would you pay for a 109?



NC Rover
02-04-2008, 09:22 PM
Found a used good running 109 w/ long wheel base. Seems to be in good shape with minimal rust. Diesel engine.

What would you pay for one? (U.S. Dollars).

leafsprung
02-04-2008, 09:43 PM
as little as possible . . .maybe more details?

Jim-ME
02-05-2008, 05:51 AM
Or a set of pictures?
Jim

NC Rover
02-05-2008, 11:06 AM
Sorry I'll try to snap a few pics when I take a look at it again today. I didn't know what the average price was for a 109 in good running condition with minimal rust. I'll work on the pictures today.

Jeff Aronson
02-05-2008, 11:17 AM
There really is no "average" price because of the age and rarity of Series vehicles. If it's a 109" SW 5 door, it will be worth a lot more than a 109" 3 door, of which there are more in the USA.

Is is a 4 or 6 cylinder?
3 door or 5 door? Tailgate in rear?
Hardtop or canvas top?
Seats or benches in rear?
Series II-A or Series III
Which diesel engine, LR or a conversion?
Mileage on the car?
Service history?
Condition of transmission, transfer case?
What do you consider "minimal rust?" (The location of the rust is far more critical than the amount, e.g, door tops are much easier to replace than a rear crossmember)
Condition of frame and bulkhead?

That said, I bought a '66 Series II-A HT with a patched frame, original engine, two sets of 16" wheels and tires, new hoop set and canvas top, straight panels and faded out paint, for $3,000 two years ago. Unless your 109" is a station wagon, there's not a lot of difference in pricing between an 88" and a 109".

As recommended, post some photos. We're all intrigued!

Jeff

madp
02-05-2008, 12:02 PM
For what its worth, last month I purchased a '73 Series 3 109 SW RHD with about 73,000 miles on it, fresh of the boat from england, it is the 2.25 petrol motor, for $5,000 us. It has some rust, but over all it is in good shape. I had to put about $1,500 into a new clutch system and tyres to get it on the road and it has all the normal old landy issues, but it gets me to work 5 days a week.

NC Rover
02-05-2008, 02:47 PM
There really is no "average" price because of the age and rarity of Series vehicles. If it's a 109" SW 5 door, it will be worth a lot more than a 109" 3 door, of which there are more in the USA.

Is is a 4 or 6 cylinder? -->4 cylinder
3 door or 5 door? Tailgate in rear? -->Door in rear..no tailgate
Hardtop or canvas top? -->Hardtop...windows were falling out in some places due to bad seals...held on by ductape.
Seats or benches in rear? --> Nothing in rear...no seats...just a big sheet of plywood on the floor so who knows what kind of rust lay hidden beneath.
Series II-A or Series III - 1980 Series III
Which diesel engine, LR or a conversion? --> It looked to be LR.
Mileage on the car? --> 110k...maybe more
Service history? --Definitly not.
Condition of transmission, transfer case? --Hard to tell...covered in dirt and oil.
What do you consider "minimal rust?" (The location of the rust is far more critical than the amount, e.g, door tops are much easier to replace than a rear crossmember) --> yeah..I never got to see it till today. Frame is in really bad shape. Body was good shape....frame and underneath...terrible.
Condition of frame and bulkhead?

That said, I bought a '66 Series II-A HT with a patched frame, original engine, two sets of 16" wheels and tires, new hoop set and canvas top, straight panels and faded out paint, for $3,000 two years ago. Unless your 109" is a station wagon, there's not a lot of difference in pricing between an 88" and a 109".

As recommended, post some photos. We're all intrigued!

Jeff

Its a 109 3-door. I finally had the chance to look it over. Its in pretty bad shape. WHen you drive by at 50mph at 50 yards, it looks good. Upon closer inspection, the frame is rusted completely through in multiple spots. I'm talking large gaping holes you could fit you arms through.

Rear cross member is rusted through. The floor panels under the driver and passenger seat are rusted through, interior would need quite a bit of work. The engine bay looked really clean. Apparently the owner converted it to bio diesel? Its a RHD but it definitly would need a new frame and most likely bulkhead. Couldnt' get a good view of that. Bummer b/c it looks like a really cool rover.

Guy was asking $5800.

Unfortunately I did not have my digital camera with me as I looked at it during my lunch break. Sorry!

msggunny
02-05-2008, 02:48 PM
Its a 109 3-door. I finally had the chance to look it over. Its in pretty bad shape. WHen you drive by at 50mph at 50 yards, it looks good. Upon closer inspection, the frame is rusted completely through in multiple spots. Rear cross member is rusted through. The floor panels under the driver and passenger seat are rusted through, interior would need quite a bit of work. The engine bay looked really clean. Apparently the owner converted it to bio diesel? Its a RHD but it definitly would need a new frame and most likely bulkhead. Couldnt' get a good view of that. Bummer b/c it looks like a really cool rover.

Guy was asking $5800.

Where was this?

It wasnt the guy from Tidewater was it?

Alaska Mike
02-05-2008, 05:15 PM
Run away.
From the sound of it, my Rover was in far, far better shape and I paid $500 for it. I'm still getting/going to get nickle and dimed to death, and I'm not using all LR parts.

All you're going to get out of that Rover that will be salvageable are a few small parts, a VIN plate, and maybe some body panels. You can do better.

yorker
02-05-2008, 05:17 PM
parts rover: $500

Saxondog
02-05-2008, 05:52 PM
I'll give you $500.00 for the engine if it's rover.

swingkeel
02-05-2008, 08:50 PM
http://http://i109.photobucket.com/albums/n64/67NADA/LandRover%201967%20109%20NADA/rodentcondo.jpg (http://[IMG]http://i109.photobucket.com/albums/n64/67NADA/LandRover%201967%20109%20NADA/rodentcondo.jpg[/IMG)



and after 10 thousand bucks it's probably worth about $5K.... but we love it !

Best Michael

BellaCoola
02-06-2008, 12:46 AM
Canuck here! Seeing as our dollar has been about par since last year...I'll give you some details on my 109 purchase in Nov.07.

1983 Series III 109
x-mod (british)
Canvas top (old and leaky)
Modified rear door and sills
2.2L petrol (122kms - documented...I think:rolleyes:
Original goodyear bias ply w/tubes

Asking: $5,900
Purchased for $3,500 - yes a very good deal, but remember these vehicles generally don't sell quickly, so most people will deal if it's been for sale for a while...cash talks.

My truck, being an x-mod was in very good shape. Solid Frame, rebuilt engine. Even though I have still aready put $5k into since then...new top, tires, brakes and cylinders, major tune up...etc...etc...

The most important item to look at is the chasis (frame). If it is rusted as you say...walk away...it is a parts vehicle now. You could throw a new 109 galvanized frame on it, but now you are talking big money $3000+++++

My advice...keep looking until you find a clean truck...they are out there.
Took me almost a year to find mine.

Good luck.

http://www.freewebs.com/83s3109

NC Rover
02-08-2008, 10:21 AM
Yeah i wasn't really in any need of another rover but I noticed it was for sale so I figured I would take a look. Even the steering damper had completly rusted through and fell off the frame. No attachment point.

I will say I do like the 109's extra room. Very cool vehicle!

Donnie
02-17-2008, 08:36 PM
There really is no "average" price because of the age and rarity of Series vehicles. If it's a 109" SW 5 door, it will be worth a lot more than a 109" 3 door, of which there are more in the USA.

Is is a 4 or 6 cylinder?
3 door or 5 door? Tailgate in rear?
Hardtop or canvas top?
Seats or benches in rear?
Series II-A or Series III
Which diesel engine, LR or a conversion?
Mileage on the car?
Service history?
Condition of transmission, transfer case?
What do you consider "minimal rust?" (The location of the rust is far more critical than the amount, e.g, door tops are much easier to replace than a rear crossmember)
Condition of frame and bulkhead?

That said, I bought a '66 Series II-A HT with a patched frame, original engine, two sets of 16" wheels and tires, new hoop set and canvas top, straight panels and faded out paint, for $3,000 two years ago. Unless your 109" is a station wagon, there's not a lot of difference in pricing between an 88" and a 109".

As recommended, post some photos. We're all intrigued!

Jeff
I wasn't aware that a 5 door was worth more than my 3 door rhd..thanks for the advice