Morning Les,
S2a. Had the slave and flex line on hand(payed to plan ahead). Ordered new push rod from you folks Fri and I should have it tomorrow. Ended up taking out the complete floor and trans tunnel etc. Struggling with getting the old flex line out of the bracket on the bulkhead and am a little nervous about adjusting the push rod length properly. I have synthetic brake caliper lube which is what I had planned on lubing the push rod assembly with, where it goes up into the slave. Will that be OK? Managed to salvage the old locknut. Am I correct that you push the clutch lever and shaft assembly down to adjust the push rod length correctly? Do you know what size tube I need to fit on the bleeder? I'm sure I'll figure it out but will most likely have more questions.
Jim
Comment