Hey folks, Its getting to be winter here in Maryland and that means I need to put the top back on my IIA 88 (the motorcycle isn't great in snow).
Here's my question: How?
Specifically, how do the 4 mounting studs/washers/bumpers go? What is so special about the rubber bumpers on the rear studs and if they're so special, then why are they NLA? Any suitable alternatives?
Lastly, I have all new gaskets, courtesy of our hosts. They seem an extra bit long-by inches. Is any of this normal? Do I just notch, nick and nip them all to fit (like around the doors & mounting studs).
Surprising, the green bible doesn't offer any good pics, and while the RN catalogue helps, all of the part numbers that they sent me differ from the catalogue.
Thanks in advance....JN
Here's my question: How?
Specifically, how do the 4 mounting studs/washers/bumpers go? What is so special about the rubber bumpers on the rear studs and if they're so special, then why are they NLA? Any suitable alternatives?
Lastly, I have all new gaskets, courtesy of our hosts. They seem an extra bit long-by inches. Is any of this normal? Do I just notch, nick and nip them all to fit (like around the doors & mounting studs).
Surprising, the green bible doesn't offer any good pics, and while the RN catalogue helps, all of the part numbers that they sent me differ from the catalogue.
Thanks in advance....JN
Comment