Zenith >> Weber

[siii8873]

I have obtained a new Weber 34 ICH carb for replacing my zenith on a 225 petrol. The carb does not have a throttle linkage. Is there an adapter linkage available or do I use the linkage from my zenith to connect the carb?

[Les Parker]

The Weber should bolt right on, use the threaded ball from the Zenith accel. lever, connect the original ball joint to the Weber and you should be ready to go.

:)

[Les Parker]

Hi,

The accel. lever on two carbs is interchangeable, hope this helps.

[MikeJW]

I've same problem and the Zenith accelerator lever won't fit on Weber - threaded shaft on the Weber is 0.5mm too big. Any other suggestions? I don't want to take the angle grinder to the Zenith accelerator lever just yet.

[SalemRover]

For a second I thought you were implying that zenith is greater than weber. Them's fightin words. I have done this swap before and you may have to play with the 2nd to last linkage that is bolted to the bulkhead to give you a little more wiggle room at the last linkage area. What are you going to do with that old Zenith? I am sure the forum folks have lots of clever ideas.

-Jason