Tweet
i just finished painting the front half of my frame. starting to put it back together. po did some brake work and it looked a little wierd. did the 5 port brake thing. it was located in front of the right footwell and right in front of my finger the little plate was attachted with 2 self tappin screws and a bolt came up thru the plate and up thru the brake thingy. was thi the way rove did it?
-
Last edited by scott; 07-22-2009, 10:54 AM.'64 Series IIA 88 Canvas Tilt
'68 Series IIA RHD Ambulance
'76 Spitfire 1500
'07 LR3 (Series Recovery Vehicle) -
That's OEM. On my 109 I saw the same thing, made some comment about SPOs and threw it out. I then looked at my 88, and then had to make a new one. -
cool, thanks'64 Series IIA 88 Canvas Tilt
'68 Series IIA RHD Ambulance
'76 Spitfire 1500
'07 LR3 (Series Recovery Vehicle)Comment
-
sort of. the forked end points forward and the 5 way stays the way it is. as shown in the parts catalogue
Originally posted by scottA Land Rover would never turn up to collect an Oscar. It'd be far too busy doing something important, somewhere, for someone."
Comment
-
guess there was more than one orientation...
Scott-
Mine's oriented exactly the way yours is pictured. Notch toward the engine.
Jeff1964 Series 2A SW, LHD mostly stock, often runs!
1991 Range Rover HunterComment
Comment