View Full Version : steering linkage & relay unit?
scott
06-14-2009, 04:48 PM
can the oil seals be replaced while this unit is still in the front cross member?
BackInA88
06-14-2009, 05:14 PM
That's the way I replaced my seals.:thumb-up:
Steve
scott
06-14-2009, 05:29 PM
cool, it looked like you coud just take of the upper and lower relay levers and pry out then slide on new seals. is that how you did it?
BackInA88
06-15-2009, 10:42 AM
I believe I removed the end caps and did the seals on the bench.
I think on the bottom side there is a sheet metal cover around the relay that has to come off first?
Steve
Terrys
06-15-2009, 11:42 AM
I had one I could never keep oil in, no matter what I did, so I took it out and drilled a 1/8" hole down the center of the shaft, and a hole in from the side, halfway bewteen the two tapers, then put a zerk in the top and filled it with grease. Was smooth as silk, and no more water getting in either.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.