Anyone near their Rover?

[SeriesShorty]

If you are near your Rover, can you run out and grab a measurement for me at the widest section of the upper wing panel? I found a good deal on some scraps of 5-bar and want to be sure it will be wide enough to make a set of wing protectors with.

Mucho thankso!

[scatterling]

my wing tops at the widest point is 14 3/4". I have the five bar plate on mine and at their widest they are 13 1/4". Hope this helps.

[SeriesShorty]

Thanks Neil, that is very helpful! Poo, the scraps are 1' x 8'. :( He's claiming that is the width that 5-bar comes in. Me thinks that can't be the case. I'll try the next supplier on the list. At least they'll be great for making some sill protectors instead! I'm happy again. :thumb-up: