I purchased a Genuine steering damper (STC 786) for my SIII Lightweight. The only promlem is what to do with some of the mounting hardware. The hardware for each end includes one thick washer and one thin washer. There appears to be only one place to put each of these washers, but I'm not sure why they are needed.
Here is the hardware for one end of the damper:
Here is ALL the hardware assembled:
Here is the way I would expect it to mount:
Unless there is a good reason for the flat washers, I'm going to mount it as shown in the last picture.
Any input?
Here is the hardware for one end of the damper:
Here is ALL the hardware assembled:
Here is the way I would expect it to mount:
Unless there is a good reason for the flat washers, I'm going to mount it as shown in the last picture.
Any input?
Comment