View Full Version : Lightweight SIII tunnel cover
xsbowes
12-26-2009, 11:51 PM
Is the gearbox tunnel on the Lightweights a standard SIII part?
jac04
12-27-2009, 09:24 AM
No, they are Lightweight-specific. Bill at TNTLR has them new if you need one. That's where I got mine.
Oh,and as a nice little surprise, I found that you need to remove the heater to install the tunnel cover.
...other neat Lightweight things that Bill has are:
1) the 598867 lifting rings for the rear cross-member for $14 each
2) the funky pieces of weatherstripping (346395) that mount to the windshield frame / upper bulkhead for $4.50 each
xsbowes
12-27-2009, 04:29 PM
Oh,and as a nice little surprise, I found that you need to remove the heater to install the tunnel cover.
Unless you cut out the part just below the heater like the PO on mine did.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.