Tweet
lit'l thingies on a new pressure plate
i just installed a new clutch and prsr plt. the prsr plt came with 3 red clips bolted to the back side. it seems i read before throwing out the instructions that after installing remove these clips. something to do with compressing the springs 'til you get it bolted in. two questions. am i remembering the instructions correctly? and i noticed on the old prsr plt i replaced that these clips were still in place, could that have led to an early death of the clutch the prv ownr insalled?
-
Last edited by scott; 03-01-2007, 04:09 PM.'64 Series IIA 88 Canvas Tilt
'68 Series IIA RHD Ambulance
'76 Spitfire 1500
'07 LR3 (Series Recovery Vehicle) -
Post a photo and maybe we will have a better idea.61 II 109" Pickup (Restomod, 350 small block, TR4050)
66 IIA 88" Station Wagon (sold)
66 IIA 109" Pickup (Restomod, 5MGE, R380)
67 IIA 109" NADA Wagon (sold)
88, 2.5TD 110 RHD non-hicap pickup
-I used to know everything there was to know about Land Rovers; then I joined the RN Bulletin Board. -
i will on the thread "clutch still slipping". i think it' may help him tooLast edited by scott; 03-05-2007, 10:40 PM.'64 Series IIA 88 Canvas Tilt
'68 Series IIA RHD Ambulance
'76 Spitfire 1500
'07 LR3 (Series Recovery Vehicle)Comment
Comment