PDA

View Full Version : Blend motors



GeoffBooth
05-25-2010, 06:01 AM
My right hand blend motor as gone bad. These thing are now $500 for some reason.

Question: I read somewhere that a servo from the fresh air duct may work to replace a single blend motor. What do you think?

joshua.mcguoirk
05-29-2010, 09:59 AM
I've been unsuccessful with this option you describe. I too have the same issue. Went to http://www.rangerovers.net and followed the advice for tear-down only to discover that the wiring was different. I too need to find a permanent solution.

I troll eBay looking for units. Every now and then you will find a set that was dismantled to sell individually. Good luck.

Whilst at the dealer one day... I asked for an estimate. ~$550.00 for part with 12 hours labour. YIKES! 12 hours? They explain that the entire dash and center console needs to be removed.

Cheers,

kevin-ct
05-29-2010, 11:28 PM
I have a customer that purchased a set of blend motors from the Uk for about $300 and I charged him 5 hrs to install them. You don't need to remove the whole dash