View Full Version : tap size? steering relay retainer
Broadstone
06-08-2010, 08:17 PM
Hoping someone knew what tap is needed to clear the galvy for bolts holding the steering relay retainer. The one on the underside of the front X-member. Thanks
martindktm
06-09-2010, 06:01 AM
Its 1/4"-28 fine thread.
Broadstone
06-09-2010, 05:33 PM
Good I have that. Thank you very much!!
martindktm
06-09-2010, 08:58 PM
The tap was hard to start when I did mine. I would recommend you to pass a drill bit through the hole before the tap.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.