SIII Footwell Replacement

[nate6472]

Anybody done this? Does it require welding, metal cutting, etc? I have been looking for these and everyone seems to be out - "sheet metal shortage . . ." Any suggestions on where I can get these?

[printjunky]

Last time I did it (around '90), it did require welding(on galvanized, about which many warnings exist, though I just went ahead ...) - though no cutting on the RN panels. But it was pretty simple. If I had to guess, I'd say a shop would do both sides for $50-$100. You'll probably find responses with more recent experience that might or might not confirm my experience.

[KingSlug]

http://www.pangolin4x4.com/pangolin4x4/reference/howto/bulkheadrepair/index.htm

This is from Ike Goss at Pangolin 4x4.

Jared

[nate6472]

Thanks, found what I need.