Results 1 to 4 of 4

Thread: Deployable side steps

  1. #1

    Default Deployable side steps

    Does anyone have installation instructions for the deployable side steps? Thanks in advance.
    1958 Series 1 88"
    1966 Series 2A 88"
    1975 Sereies 3 109" Carmichael Fire Truck

  2. #2


    they are assembled off the car, then they mount on the existing holes on the inside of the rocker pannel, these are covered by round pieces of what looks like duct tape... the motor connector is existant on the car, the installation is plug and play down to the roof mounted manual activation button.
    here is the fun part, you need to programm and activate the module using test book or a similar land rover diagnosis tool/ scanner.

  3. #3


    Thanks, Phoenix. Where is the pass through to vehicle interior to feed wiring and where is the plug in? I'm guessing the back near spare tire, through same hole as trailer plug? For ceiling switch, do you have to run wiring down pillar?

  4. #4


    no, if i reccall correctly the plugs are existent to the location, the front fender liners hide the external plugs and the inside is wired all ready just plug and play plus a little programming.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us